CLI to display the Vumeter

[PaulH]

Which command to send to display the vumeter ?
And back ? (like the single press on the touch display !)

Thanks

[paul-]

It cannot be changed from command line, only from touching the jivelite interface. Just touch the artwork on the jivelite display.

You can change which of the screen layouts are default, and which ones are included in the rotation. Look at the jivelite settings.

[PaulH]

It cannot be changed from command line, only from touching the jivelite interface.

ok! it's a pity. It's would be nice to "remote control" the "look"! ;-)

It cannot be changed from command line, only from touching the jivelite interface. Just touch the artwork on the jivelite display.

You can change which of the screen layouts are default, and which ones are included in the rotation. Look at the jivelite settings.

I had seen! Thanks !

[PaulH]

It cannot be changed from command line, only from touching the jivelite interface. Just touch the artwork on the jivelite display.

You can change which of the screen layouts are default, and which ones are included in the rotation. Look at the jivelite settings.

A new idea....

Is it possible to switch the display (vumeter and back) with an hardware pin set as input ???

Thanks

[PaulH]

It cannot be changed from command line, only from touching the jivelite interface. Just touch the artwork on the jivelite display.

You can change which of the screen layouts are default, and which ones are included in the rotation. Look at the jivelite settings.

Is my idea faisable or not :


Is it possible to switch the display (vumeter and back) with an hardware pin set as input ???

thanks