Quote Originally Posted by paul- View Post
For sure you can look at dmesg, and see if there are kernel logs showing low voltage.

Greg,

At one point we were going to add the voltage alarms somewhere on the web interface......do you recall if/what we were going to do?
Hi Paul,

I was only thinking about it yesterday when one of my test RPi produced a message 10 seconds into booting.

Code:
[   10.886549] Under-voltage detected! (0x00050005)
I was trying to determine if you just report during boot or add a check to the diagnostics page(s), probably both.

I don't think a contiguous monitor is necessary?

I have added it to my TODO list.

regards
Greg