Hi there,
i tried to set up a Pi1B together with a 3.5 TFT with PCP6.0 following this guide http://www.pughx2.com/picore3.html
i got Jivelite running but touch didn't respond. So i went back to PCP 4.1 as stated in the guide. Got jivelite showing up but touch didn't work here either.
I have read through the entire thread and understand that the instructions reflect the current status that was discussed here - right?
So touch should work with this.
Would you please be so kind to help me trouble shooting?

I can provide my settings in the evening when I am back home

Regards
Patrick