Home of the Squeezebox™ & Transporter® network music players.
Page 6 of 6 FirstFirst ... 456
Results 51 to 58 of 58
  1. #51
    Senior Member
    Join Date
    Feb 2011
    Location
    Cheshire, UK
    Posts
    4,880
    Quote Originally Posted by Marsupial View Post
    I have a raspberry pi that I would pair with the changer, and access to ethernet not too far.

    What I'm missing is audio input to the pi.

    I've seen I2C ADC for next to nothing on eBay but doubt this will be good enough..?
    Behringer UCA 202 - I have 2 and they work fine into a Pi2 and a Pi3 although a purist would say use a Pi4 as the USB is separated from the Ethernet in the later model.
    Only about ú25 but they are limited to 16/44.1 or 16/48 - more than enough for vinyl.

    I take the audio via alsa input into Liquidsoap, then out to an Icecast server on the Pi. It streams out in FLAC quality. I then "Tune in URL" in LMS. There is a noticeable lag.
    I run the Behringer inline from source to an aux socket on my amp. This effectively does a passthru of the audio signal if you arent using the streaming mode.

    Alternatively use piCorePlayer and enable pcp Streamer. This does essentially the same but when I first tried it it ihad pops and clicks which my homebrew solution doesn't. It may well be better now we are at 6.10.
    piCorePlayer also works with a Behringer UCA 202 confirmed.

    https://www.gear4music.com/Recording...SABEgKu3fD_BwE
    VB2.4 storage QNAP TS419p (NFS)
    Living Room - Joggler & SB3 -> Onkyo TS606 -> Celestion F20s
    Office - Pi3+Sreen -> Sony TAFE320 -> Celestion F10s / Pi2+DAC & SB3 -> Onkyo CRN755 -> Wharfedale Modus Cubes
    Dining Room -> SB Boom
    Kitchen -> UE Radio (upgraded to SB Radio)
    Bedroom (Bedside) - Pi2+DAC ->ToppingTP21 ->AKG Headphones
    Bedroom (TV) - SB Touch ->Sherwood AVR ->Mordaunt Short M10s
    Everything controlled by iPeng

  2. #52
    Senior Member
    Join Date
    Feb 2013
    Posts
    118
    I realistically need only one input (mono) to usb... Aren't there other vendors than Behringer?

  3. #53
    Senior Member
    Join Date
    Feb 2011
    Location
    Cheshire, UK
    Posts
    4,880
    Quote Originally Posted by Marsupial View Post
    I realistically need only one input (mono) to usb... Aren't there other vendors than Behringer?
    Yes there are other vendors but I doubt you will find a mono version. Get a two into one cable or correct in software.
    VB2.4 storage QNAP TS419p (NFS)
    Living Room - Joggler & SB3 -> Onkyo TS606 -> Celestion F20s
    Office - Pi3+Sreen -> Sony TAFE320 -> Celestion F10s / Pi2+DAC & SB3 -> Onkyo CRN755 -> Wharfedale Modus Cubes
    Dining Room -> SB Boom
    Kitchen -> UE Radio (upgraded to SB Radio)
    Bedroom (Bedside) - Pi2+DAC ->ToppingTP21 ->AKG Headphones
    Bedroom (TV) - SB Touch ->Sherwood AVR ->Mordaunt Short M10s
    Everything controlled by iPeng

  4. #54
    Senior Member
    Join Date
    Feb 2013
    Posts
    118
    Anyone has experience with non-berhinger ones?

  5. #55
    Senior Member Jeff07971's Avatar
    Join Date
    Aug 2011
    Location
    London, England
    Posts
    1,508
    Quote Originally Posted by Marsupial View Post
    Anyone has experience with non-berhinger ones?
    Yes when the feature was first added to pCP I tried it with one of these (super cheap) USB soundcards

    https://www.ebay.co.uk/itm/External-...IAAOSwhvFZHdMj

    I do not remember having any problems with clicks etc.

    Of course theres HATS from HifiBerry and iQaudio that have inputs (I believe this feature has been tested with the HifiBerry HAT but cannot say for sure)

    Jeff

    Want a webapp ? Get SqueezeLite-X ! https://forums.slimdevices.com/showt...l=1#post903953

  6. #56
    Senior Member Jeff07971's Avatar
    Join Date
    Aug 2011
    Location
    London, England
    Posts
    1,508
    Quote Originally Posted by d6jg View Post
    Yes there are other vendors but I doubt you will find a mono version. Get a two into one cable or correct in software.
    I don't think there is a reason to "correct in software" ?

    Both channels will be the same if you use a 1-2 cable anyway

    Jeff

    Want a webapp ? Get SqueezeLite-X ! https://forums.slimdevices.com/showt...l=1#post903953

  7. #57
    Senior Member
    Join Date
    Feb 2011
    Location
    Cheshire, UK
    Posts
    4,880
    Quote Originally Posted by Jeff07971 View Post
    I don't think there is a reason to "correct in software" ?

    Both channels will be the same if you use a 1-2 cable anyway

    Jeff
    I said OR correct in software. Meaning if he chose to use L to L only (or R to R) then it would be fine if you tell alsa accordingly but a 1-2 cable is preferable.
    VB2.4 storage QNAP TS419p (NFS)
    Living Room - Joggler & SB3 -> Onkyo TS606 -> Celestion F20s
    Office - Pi3+Sreen -> Sony TAFE320 -> Celestion F10s / Pi2+DAC & SB3 -> Onkyo CRN755 -> Wharfedale Modus Cubes
    Dining Room -> SB Boom
    Kitchen -> UE Radio (upgraded to SB Radio)
    Bedroom (Bedside) - Pi2+DAC ->ToppingTP21 ->AKG Headphones
    Bedroom (TV) - SB Touch ->Sherwood AVR ->Mordaunt Short M10s
    Everything controlled by iPeng

  8. #58
    Senior Member Jeff07971's Avatar
    Join Date
    Aug 2011
    Location
    London, England
    Posts
    1,508
    Quote Originally Posted by d6jg View Post
    I said OR correct in software. Meaning if he chose to use L to L only (or R to R) then it would be fine if you tell alsa accordingly but a 1-2 cable is preferable.
    Sorry read it too quickly !

    Want a webapp ? Get SqueezeLite-X ! https://forums.slimdevices.com/showt...l=1#post903953

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •