If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
This is still a work in progress, where we can easily create web pages with HOTO's and other information. If you have something you would like included, creates a simple web page and let us know.
And last but not least, corrections to the inplace update process
Reloading the reboot page should no longer reboot your pCP device again.
You can now do an insitu_update and change from pcpCore to pcpAudioCore, and vise versa.
For the adventuresome 3.11 users reading this, If you do a hotfix (Near the bottom of the Main Page in Beta Mode), this will install a small fix, that will allow you to do an insitu_update to 3.20.
By my tests, if you are using a 3.11 image, when you install 3.20, you should have about 180k of disk space left on the boot partition. 99% Full. In my mind this is a bit risky, but I suppose if your card is not easily pulled, give this a try. Worse case you have to pull your card and reflash.
I use auto in channel but still fail . what section I need to set I in my rounter I work fine in 3.11 thanks
Please fix your router to use channel 1 and retry. Just to eliminate; sometimes the high channels do clash with the WIFI drivers.
Also verify you did not disable the onboard wifi ( RPi Built-in Wifi must be ON at http:\\x.y.z.h/cgi-bin/wifi.cgi )
You need a wired ethernet connection to check this.
Pi based multi-room audio system powered by PiCorePlayer(s):
Pi3B with Phat-dac in a Rasptouch, 2 pi B+ with Cirrus Logic Audio Card, Pi Zero with Phat-beat , and a few other tests...
Because 3.11 uses a 4.4.39 based kernel, and 3.20 uses a 4.9.21 based kernel. The drivers have quite a few changes. Plus the RPi 3 wifi is still a very flawed hardware implementation.
Please confirm that you are using the kernel version 4.9.21-pcpCore_v7. This is shown in the footer of the web pages.
I used the hot fix and continued with the in situ update. No problems and the connection to my WiFi dongle fired right up. RPi3 with HiFiBerry Digi+ hat, TP Link WiFi dongle, Adafruit 5.25V 2A power supply with Monoprice USB power cable with ferrite core. piCorePlayer 3.20 Audio Version on 8GB Samsung Evo micro SD card. It might be my imagination but I think it may sound better than the 3.11 version. Call me crazy.
Glad you like it. The kernel continues to evolve, there are many sound system changes in the 4.9 kernels. Some of those patches would have been backported into the 4.4.39 Audio kernel......now they are in the default kernel.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
F:ED
Comment