If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Followed the instructions, I get code at boot, but if jivelite is enabled it goes to a black screen. If autostart isn't enabled, it stays showing the start code and IP address.
Re done it a few times, same result. Anyone got any ideas?
I assume that you are talking about a Rasberry Pi running pCP? I have no hands-on experience with adding a screen to a Pi, but did you follow these instructions?
Also, if you want help it would help to add information about RPi model, exact screen type, which pCp version, etc.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment