PDA

View Full Version : linux IR question



MadScientist
2009-02-06, 02:40
I'm trying to modify an applet for the Controller so I can use it to control my amp which for its IR control uses the RC-5 system address 19 (0x13). I can get half of each code from the link below but I can't work out what hex pre-data to add in front of each code in order to complete each of the commands.

http://lirc.sourceforge.net/remotes/meridian/MSR

I'm not even sure that the Controller LIRC can work for RC5 type remotes.

Can any LIRC experts help?

Thanks

MS

chriscc
2009-02-10, 06:05
MS,

Would it help if you converted your RC5 codes to raw format? (I don't have the applet installed)

Regards,
Chris

chriscc
2009-02-10, 11:03
... and looking at the LIRC conf file, I think your raw Volume Up code would look something like:

890 890 890 890 890 890 1780 890 890 1780 890 890 1780 1780 1780 890 890 890 890 890 890 890 113792

And Volume Down something like:

890 890 890 890 890 890 1780 890 890 1780 890 890 1780 1780 1780 890 890 890 890 1780 890 113792

Regards,
Chris

MadScientist
2009-02-11, 14:20
Thanks, I'll give them a try

NS