PDA

View Full Version : Setting up Duet when Receiver and Controller in different subnets.



dramus
2008-06-04, 07:16
My WiFi subnet is 192.168.15.1, my wired ethernet subnet is 192.168.106.1

I can set the Controller up fine. No issues, as far as I can tell.

When I try to setup the Receiver, the Controller sees it and I tell it to use Ethernet rather than Wireless...It tries, but eventually I get a blue light on the Receiver and the controller says that the setup failed.

If I put them in the same subnet (as a test), it sets up just fine. So I known the Receiver works.

I suspect the Controller is sending some of it's network config details to the receiver for it to use and because they are in different subnets, that is causing it to fail.

Has anyone else tried to setup over two subnets?