PDA

View Full Version : Controller Will Not Recognize My New Rounter



oldschool
2008-04-25, 17:46
My controller will not connect to my new NetGear router. I reset the controller it to factory defaults and downloaded the nightly build but to no avail.

SqueezeCenter Information:
SqueezeCenter Version: 7.0.1 - 18946 @ Sun Apr 20 00:22:04 PDT 2008 - Windows Vista - EN - cp1252
Server IP address: 10.0.0.3
Perl Version: 5.8.8 MSWin32-x86-multi-thread
MySQL Version: 5.0.22-community-nt
Platform Architecture: 586
Hostname: HP-Office
Server Port Number: 9000

System Details:
Router: NetGear Wirless-N Gigabit Router, Model WNR3500 with SSID broadcast enabled and WPA-PSK [TKIP] + WPA2-PSK [AES] enabled
PC: Windows Vista Ultimate 64bit
Wireless: 802.11b,g,n, channel 6,10 (on router)

Help!!!!!!!!!!!!!!

Anoop M.
2008-04-25, 18:05
After downloading 7.0.1 did you connect your player via hardwire to get the firmware update needed to correct the wireless issues with the receiver not being able to connect?

fcm4711
2008-04-28, 01:45
Hi there

As Anoop pointed out there was a connection issue with that particular router when wireless encryption is turned on (but as far as I know the issue only exists for Squeezebox Receiver, not for Squeezebox Controller).

So, optionally you could try the setup without any wireless encryption turned on first to get all relevant updates and turn it on again afterwards.

The issue has been fixed for SBR in firmware 23.

Felix

oldschool
2008-05-17, 06:32
I ran an ethernet cable from my router to the player and now it works fine.

Thanks to everyone for your advice.