PDA

View Full Version : Inguz question



joeriz
2007-11-16, 15:10
I installed Inguz today (full install) and everything seemed to go fine. I have noticed, however, that I must re-start the current track (or skip to the next one) to get any new EQ settings to take effect. (NOTE: I am using only the EQ capabilities.)

Is this normal behavior for Inguz? I did not see anything about this in the instructions.

My PC is probably 4 or 5 years old but it meets the stated requirements for Inguz (it is a Pentium 4 CPU 2.4GHz with 1GB of RAM and 40GB free hard-drive space).

Thanks,
Joe

joeriz
2007-11-16, 16:22
Oops...nevermind. I just found this on the Inguz 'caveats' page:

"Changes to any EQ settings will not take effect immediately. Most changes will actually begin to be processed immediately, but the Squeezebox has a large buffer, which will usually be full of processed data already, so you won’t hear the change until a while later (several seconds, or in the worst case until the start of the next track)."