.
-
Last edited by rbz5416; 2011-06-07, 21:29. -
I don't kow the specifics of the SB2 headphone socket, but for general electronics:
[Project Log] Funkstars Digital Lifestyle - HEXUS.Community
In use: 1x Touch, 1x Boom, 2x SB3, 1x Controller
In a box: 1x Radio, 1x (Beta) Controller, 1x Receiver, 1x SB2 wired (silver), 1x SB (black), 1x SliMP3 (with rear shield)
If you have any others, let me know, I'm interested!!
-
If I were you I'd remove the duf socket and hard wire flying leads to a more robust in line connector...this will prevent the pluging and unpluging of headphones from damaging the pcb mounted device...
I've a box full of dead walkmans where the pcb mount socket has damaged the pcb beyond useful repair[actually my wife throw them out!]Acoustician and builder of interesting cablesComment
-
Alternatively
Take the line out signals to a decent headphone amp. Slimdevices themselves admitted in a separate thread that they didn't spend a lot of money on their circuit...I've got a fever above my waist
You got a squeeze box on your knee
I know the truth is in between the 1st and 40th drink - Tori Amos
Squeezebox Classic -> NAD T743 -> Krix Phoenix
Oh, and a BOOM...Comment
-
Personally I'd try Toby Electronics:
Comment
Comment