PDA

View Full Version : Help with Linksys WET54G Wireless-G Ethernet Bridge?



Richard Machin
2003-11-12, 09:54
You might try getting a long Ethernet cable between your WAP and the DSL
modem, and moving your WAP up as suggested. They hate transmission through
bulky structures, especially across angles that 'widen' the apparent junk
they need to travel through. I'm using wireless without problems (after
increasing the default packet size on my Win2K server to get rid of the
fast-forward effect).

Thanks -- first post, great work from the slim folks!

-----Original Message-----
From: discuss-bounces (AT) lists (DOT) slimdevices.com
[mailto:discuss-bounces (AT) lists (DOT) slimdevices.com] On Behalf Of Sean Adams
Sent: Wednesday, November 12, 2003 8:36 AM
To: SLIMP3 Discussion
Subject: [slim] Help with Linksys WET54G Wireless-G Ethernet Bridge?


David,

You might want to look into homeplug (ethernet bridging over the power
lines) as an alternative.

Sean

On Wednesday, November 12, 2003, at 07:11 AM, DG wrote:

> Hello all,
>
> I've got my Slimp3 hooked into the Linksys Wireless Bridge (which is
> communicating with a Linksys WRT54G Wireless-G Access Point +
> Cable/DSL Router down in my basement). Problem is it cuts out way too
> often -- it's just much too unreliable. Sometimes the SLimp3 can't
> find the server, often it can, plays for an hour or two, then can't,
> sometimes it can play all day, sometimes it plays but if you walk
> across the room it cuts out... you get the idea... Does anyone have
> experience with this equipment and going 50-100 feet through floors?
> Anyone tried a range extending solutions that work? I've considered
> laying ethernet cable or moving the computer upstairs, but neither
> solution is a very good one for me...
>
> Thanks in advance for any suggestions,
>
> David
>