PDA

View Full Version : SB3 alu beezle falling off - how to fix it?



docbee
2005-12-27, 06:50
Hi,
my alu beezle of the sb3 seems to get loose. I remember that somewhere in the forum Sean said that you can easily fix this with the help of some super glue. As I don't want to put any harm to my SB3 I just wanted to ask if there is something to keep in mind when doing the repair.

Is it just pulling off the loose part, removing any glue that might be still there (how?), putting new glue at some points (which?) and putting it together?

Do I risk to fold the beezele when tearing it from the SB3? Looks quite thin and not very form stable to me.

Has anyone been doing this with success before?

Kyle
2005-12-27, 07:02
Before removing it, try loosening the screws on the rear of the device that may be pushing the plate away from the body. Then, press the plate back on. Earlier posts indicated this might solve your problem.

dean
2005-12-27, 14:09
On Dec 27, 2005, at 6:02 AM, Kyle wrote:

>
> Before removing it, try loosening the screws on the rear of the device
> that may be pushing the plate away from the body. Then, press the
> plate back on. Earlier posts indicated this might solve your problem.
This is better advice than using super glue. If that doesn't resolve
it, get in touch with support (AT) slimdevices (DOT) com and they can send you a
replacement that is slightly less deep and won't push against the
back case.