SB1 and SB2 Case interchangeable?

[Jason]

I hate to be an ass, but did these really have to be sent out as an
attachment. It easily could have been loaded to a web server and linked to
this message.

It just took about 20 minutes to receive this msg.

> -----Original Message-----
> From: discuss-bounces (AT) lists (DOT) slimdevices.com
> [mailto:discuss-bounces (AT) lists (DOT) slimdevices.com] On Behalf Of Sean Adams
> Sent: Wednesday, March 30, 2005 7:30 PM
> To: Slim Devices Discussion
> Subject: [slim] SB1 and SB2 Case interchangeable?
>
>
> On Mar 30, 2005, at 9:57 AM, Matt Alioto wrote:
>
> > Quick question.
> > Are the cases for the SB1 and SB2 interchangeable?
> > I would like to buy a wired SB2 and wrap it in an orange case
> >> From a SB1.
> > Will it fit?
>
> A very minor modification is needed. You need to snip off a
> plastic peg, one from the top and one from the bottom, as
> shown below. This is needed to accommodate the larger 320x32 display.
>
> Those particular pegs aren't needed any more - they were just
> for when we had separate PCBs for the 40x2 character display
> and the IR sensor (ie non-graphic Squeezebox1). See below:
>
>
>

[seanadams]

Good point - sorry.

I just had those images lying around already so I dragged them into the
compose window without really thinking about it.



On Mar 30, 2005, at 7:24 PM, Jason wrote:

> I hate to be an ass, but did these really have to be sent out as an
> attachment. It easily could have been loaded to a web server and
> linked to
> this message.
>
> It just took about 20 minutes to receive this msg.
>
>> -----Original Message-----
>> From: discuss-bounces (AT) lists (DOT) slimdevices.com
>> [mailto:discuss-bounces (AT) lists (DOT) slimdevices.com] On Behalf Of Sean Adams
>> Sent: Wednesday, March 30, 2005 7:30 PM
>> To: Slim Devices Discussion
>> Subject: [slim] SB1 and SB2 Case interchangeable?
>>
>>
>> On Mar 30, 2005, at 9:57 AM, Matt Alioto wrote:
>>
>>> Quick question.
>>> Are the cases for the SB1 and SB2 interchangeable?
>>> I would like to buy a wired SB2 and wrap it in an orange case
>>>> From a SB1.
>>> Will it fit?
>>
>> A very minor modification is needed. You need to snip off a
>> plastic peg, one from the top and one from the bottom, as
>> shown below. This is needed to accommodate the larger 320x32 display.
>>
>> Those particular pegs aren't needed any more - they were just
>> for when we had separate PCBs for the 40x2 character display
>> and the IR sensor (ie non-graphic Squeezebox1). See below:
>>
>>
>>
>
>