PDA

View Full Version : SB1 and SB2 Case interchangeable?



Matt Alioto
2005-03-30, 10:57
Quick question.
Are the cases for the SB1 and SB2 interchangeable?
I would like to buy a wired SB2 and wrap it in an orange case
From a SB1.
Will it fit?
Thanks

The information contained in this e-mail is strictly confidential and for the
intended use of the addressee only; it may also be legally privileged and/or
price sensitive. Notice is hereby given that any disclosure, use or copying
of the information by anyone other than the intended recipient is prohibited
and may be illegal. If you have received this message in error, please
notify the sender immediately by return e-mail. All e-mail sent to this
address will be received by Acacia Pacific Holding's e-mail system and is
subjected to archiving and review by someone other than the recipient.

Acacia Pacific Holdings has taken every reasonable precaution to ensure that
any attachment to this e-mail has been swept for viruses. We accept no
liability for any damage sustained as a result of software viruses and
advise you carry out your own virus checks before opening any attachment.

seanadams
2005-03-30, 19:30
On Mar 30, 2005, at 9:57 AM, Matt Alioto wrote:

> Quick question.
> Are the cases for the SB1 and SB2 interchangeable?
> I would like to buy a wired SB2 and wrap it in an orange case
>> From a SB1.
> Will it fit?

A very minor modification is needed. You need to snip off a plastic
peg, one from the top and one from the bottom, as shown below. This is
needed to accommodate the larger 320x32 display.

Those particular pegs aren't needed any more - they were just for when
we had separate PCBs for the 40x2 character display and the IR sensor
(ie non-graphic Squeezebox1). See below: