Activity Stream

Oh, you‘re right. You wrote PC and somehow I had Raspberry on my mind.

Does that apply to something that is not a Raspberry Pi?

Thx ❤️. Looking forward to see this implemented!

ohhh...so the "change" is the volume, not the settings, or tracks. Makes sense. I guess I got thrown off by him mentioning it worked for the first...

I got the impression the first couple of times the volume of a player was changed the volume of the other player was not affected. The third time the...

right, and sometimes they offer a bridged mode, and sometimes not. I have been told when they don't, just turn the radios off. I had done that...

I'm a bit unclear as to what happened between "solved" and "argh, it's back". Specifically, you mention "first two changes" then "third onward"...

Not currently - implemented for Material 2.9.6

The hub they supply is a combined cable modem and router so like you I run it in modem only mode. Sent from my Pixel 3a using Tapatalk

Good call. This would explain why so many of us have no problem running locally with no isp present. The specific router. I have always run an Asus...

I know Craig did not wan't to add anything to the menu in the playlist. I just discovered the possibility to add custom entries to the menu. I...

Check you`re QLMS.conf on PERL=, or if there does exist a file .PERL in .qpkg/LogitechMediaServer. If exist remove it, or in .QLMS.conf it says...

I don’t have a Mac to try this on … but looks like you can configure a Mac to be AirPlay receiver ...

I can't repoduce this. Works as expected here. Shouldn't make a difference whether you use built-in or custom dpls anyway. Since CS3 filter sets are...

Well setting 320k/aac works OK for me. Sent from my Pixel 3a using Tapatalk

Thank you, I knew it. But I need a second HomePod Mini before trying. :) Will buy one tomorrow.

You're right it does add album or track to the Tidal library. You learn something new every day Sent from my Pixel 3a using Tapatalk

I‘m not sure since I don‘t use Ubuntu. Try /boot/config.txt or /boot/firmware/config.txt. Change or add this line: dtparam=audio=off Then reboot.

I did as described, same Perl version 5.24.4

Try removing parameters from the Squeezelite command line - leaving you with just the output device and debug

Well, too early :( The first changes of the volume were fine but now it's back to the coupled behaviour. I only tested it within a track, i.e....

Sorry, I don't know which config.txt you mean. Where can I find it? squeezelite -l Output devices: null - Discard...

Try LMS/Settings/Player/yourDevice/Audio/Output Channel Mode

Hello everyone, I am based in France. It's been a week since Spotty stopped working for me. It tells me that the credentials are missing. When I...

I think he wants to save the albums as Tidal favourites (so they appear in a Tidal account) not LMS favourites. Sent from my Pixel 3a using...

There was a recent post where someone found an album that was only available at 320kbps wouldn't play in the Tidal app. Changing the streaming format...

I never had a hi-fi subscription, and nobody told me that now I do. It seems that you were right and I had changed the streaming format, probably...

One of the reasons I acquired a separate router was because the hub my ISP supplied refused to allow the WiFi (or ethernet?) to operate when the...

For those who dont see perl 5.34 after upgrading QLogitechMediaServer to 2.30.02. Logon to you`re QNap nas-system by ssh shell. Do , press y...

Sounds like good luck rather than good management. By default, the RPi0W has no default sound card to turn off. If you happen to plug in a HDMI...