Only Access to LAN, not to Internet

[henfri]

Hello,

Some days ago, I had to change my Router by a newer mode. By this, the IP of my router/gateway changed from 192.168.178.2 to 192.168.178.1. I could keep the Wireles settings the same though.
Since then, I had no Internet-Acces anymore from my Squeezebox Duet. Thus, I could play local music, but all mysqueezebox.com related things failed and including Web-Radio.

Thus, I tried to re-establish the connection to my wireless network. But for some reason, it wouldn't find my network. Thus, I did a factory reset, after which my Wireless network was found again.
Nevertheless, I still have no Internet connectivity, which can be seen, as accessing mysqueezebox.com fails.

The IP that was assigned via DHCP is valid/fits to my network. Signal strength is 84%

What's interesting: The Server-IP as reported in the Duet is 127.0.0.1.

The Network test (throughput) works -I didn't run it to the end. It takes ages.

Check Network also does not report errors.

DNS, Gateway and Subnet are correct. (Checked under Diagnosis, Wireless-Information; Is this regarding the Receiver, or the Controller? Where can I check the respective other????)

Ping from the Server to mysqueezebox.com works.

But when I try to connect to mysqueezebox.com, a connection is not possible.

- Controller firmware version
7.6 r9545

- Receiver firmware version
77

Plus:
- Router details (make, model, firmware version)
AVM Fritz Box
- SqueezeCenter version (if installed)
Version: 7.6.2 - r33593

- What connection method are you using? (All wireless, Controller wireless & Receiver wired, or Bridged)
All Wireless.

I hope, someone can help me. I'm out of Ideas...

Greetings,
Hendrik

[henfri]

Oh dear..
I wrote too lengthy, didn't I? ;-)

[w3wilkes]

To check the IP of the receiver you can see it from the webUI settings - Information tab or you can see it from the attached devices screen of your router. I don't know how you'd display what the receiver has for a gateway address. You should probably do a factory reset on the receiver and controller and set them up from scratch (many recent threads on doing this).

I'm all wireless for receiver and controller with no problems.

[henfri]

Thanks a lot. I'll try.

Greetings,
Hendrik