receiver LED cycling all colors!

[blakelock]

hey all,
looooove the product but hate the rare problems.

i'm having some trouble with the receiver not finding the network. i'll be calling tech support tonight. however, at one point, i unplugged the receiver for ~24 hrs then powering back up. the LED then continually cycled through all colors! red - green - blue - white - red - green - blue - white - etc...... the cycle was quick (~8 sec to go through all colors). i tried the factory reset and nothing changed. i then powered it down and back up again and it started behaving ~normally. it still wasn't connecting to network but at least i had a slowly blinking red led.

any ideas what this means?

[andynormancx]

I don't know what the fast cycling means, but the slowly blinking red means it is ready to be setup via your Controller after you performed the factory reset. So go ahead and try and set it up, if you haven't already tried.

[radish]

Sounds like you put it in test mode: http://wiki.slimdevices.com/index.ph...ntButtonAndLED