force static IP address

[BubbleSoap]

Hi there,
does anybody know how to force a static IP address to the receiver?
at moment DHCP service assigns the IP for the receiver, but i'd like to choose one because i can set up the QoS in the router to give priority to the traffic of the receiver.
Thanks in advance

[morsejeff]

There may be other ways, but you could just figure out the MAC address of the receiver and program the router to assign a certain IP address for that MAC address.

[BubbleSoap]

i'd prefer to assing a static ip address in the receiver...
i know if the DHCP is disabled the receiver will ask you to give it a static ip address (so it will let you choose one).
how can i get into this menu?
can i log in through telnet?

thanks in advcance to all the forum

[Howard Passman]

i'd prefer to assing a static ip address in the receiver...
i know if the DHCP is disabled the receiver will ask you to give it a static ip address (so it will let you choose one).
how can i get into this menu?
can i log in through telnet?

thanks in advcance to all the forum

Really,the only easy way to statically assign an IP address to your receiver is to turn of DHCP in your router. If your receiver can't get an address from DHCP, it will ask for a static one. Generally the main web page for the router is where that setting can be switched off and on. Depending on how many devices you have, you may want to assign static ip's to all of them. Some of us consdier this the easiest way to deal with networks, some of us don't. If you ever use WOL (Wake on LAN) you have to statically address.

Howard

BTW, if you have more than one router, you must turn DHCP off in them all.

[BubbleSoap]

thanks
but, will the static ip address stay after i will set the DHCP on again and after a reboot (not reset) to the receiver?
byeeeee

[Skunk]

thanks
but, will the static ip address stay after i will set the DHCP on again and after a reboot (not reset) to the receiver?
byeeeee

You shouldn't need to turn DHCP off. What you want is a static DHCP address, which as mentioned is assigned by MAC address. Since this is set in the router, and the MAC address of the device doesn't change, the Receiver will always use the given address, even after resetting the Receiver. Look for the DHCP settings on your router config page to see if there is a 'static DHCP' option. I gave the server, Controller, and all SB's static addresses, but left DHCP on for any other devices that want to connect.