How do I configure Softsqueeze to output it's audio signal to a specific set of speakers on the sound card?
I'd like to be able to run multiple instances of Softsqueeze, but have no idea where to start when it comes to routing the output of each softsqueeze player.
Can I use the 3 different pairs of audio outputs on my sound card (left/right, rear left/ rear right, and sub/center) as individual outputs to allow 3 soft squeeze players to drive 3 sets of separate speakers?
Has anyone done something like this?
Any ideas/thoughts are welcome, as it may help me find a direction to continue my research for this project.
Results 1 to 1 of 1
Thread: Softsqueeze audio setup on linux
2007-02-25, 06:34 #1
Softsqueeze audio setup on linux